Blue sea systems 4600 ryzex way bellingham wa 98226 usa 2006 2020 blue sea systems.
Blue sea systems cable clam waterproof through deck fittings.
Toll free 800 222 7617 united states and canada email.
Cable clams fit any size cable and are easily installed through the use of a seal that can be easily drilled slit slipped over the cable and then compressed inside the cable clam.
Blue sea systems cableclam sealed thru deck connectors.
Good product except one of the screw fitting stripped out in the plastic.
I actually used this to run a nmea network cable through a bulkhead to a gps receiver assembly.
Blue sea systems side entry cableclam with stainless steel dress cap.
Blue sea systems side entry cableclam with stainless steel dress cap.
Clam clam.
5 0 out of 5 stars a.
Blue sea systems 4600 ryzex way bellingham wa 98226 usa 2006 2020 blue sea systems.
Drilling a hole to pass an antenna cable through a rooftop or transom can allow water to pass through if not properly sealed.
Toll free 800 222 7617 united states and canada email.
Cableclams provide a waterproof pass through for antenna transducer and other cables without removal of the factory installed cable connector.
Just drill a hole large enough for the fitting run the connector cable through the gasket center and through the entry point in the wall push the clam into the hole whilst bending the cable through the side entry point and affix to the wall.
Cableclams provide a waterproof pass through for antenna transducer and other cables without removal of the factory installed cable connector.
Restmo 2 pack of ip68 waterproof solar cable entry gland weather resistant dual cable entry housing for solar panels of rv caravan marine boat cabin white.
Marine product expert chuck hawley talks about blue sea systems cable clams.
Drilling a hole to pass an antenna cable through a rooftop or transom can allow water to pass through if not properly sealed.
I probably overtightened it but.
Cable clams allow the waterproof through deck installation of loran gps and other cables without the expense time and risk of cutting factory installed connectors.